Version - 2016
This course is intended for users who need to create assemblies of suspensions and full vehicles, including driveline components, and then analyze them to understand their performance and behavior. Presented in the class are all of the basics of building models in Adams/Driveline (engine, gearbox, prop shafts, and differentials), running simulations and simple plotting with Adams/PostProcessor.
Topics:
- Understanding features of Adams Driveline
- Modeling Components in Adams Driveline
- Understanding different components:
- Gear Forces
- Gear Pairs
- Gearbox Assembly
- Differential
- Differential-Limited Slip Diff
- Torque Converter
- Flexible Connection
- Components
- Other Modeling Components
- Exercise on Modeling Gearbox and Driveline components
- Driveline Analysis
- Driveline Analyses
- Understanding different analyses in Adams /Driveline
- Setting up Initial-Velocity Analysis
- Specific Test analysis
- Running analyses and post-processing and investigating results in Adams/Post-Processor
- Full Vehicle Analysis
- Communicators
- Setup the powertrain/driveline model for a full vehicle
- Preparation for Quasi-Statics- understanding requirements that need to be fulfilled in order to support Quasi-Static setup analysis
- Performing full vehicle analysis
- Post-processing and investigating results in Adams/Post-Processor
ALL DESIGN & ENGINEERING CONTENT IS FOUND IN THE DESIGN & ENGINEERING eLEARNING SUBSCRIPTION.
Anytime, anywhere!
The Design & Engineering (D&E) e-learning Subscription offers access to over 50 simulation skills courses and over 1000+ hours of training material.
You can find the entire course catalog HERE.
After purchasing the subscription, you can access your courses by navigating to the My Courses page.
