The "Assessment" tab contains various graphics for analysing (assessing) the evaluation results. Essentially, these are graphics that present summarised information for assessing capabilities and results.
The "Assessment" tab is divided into three groups.
- "Entire data pool"
This graphics group summarises the graphics used to evaluate all the loaded data. Here, a distinction is made between graphics representing the entire dataset and graphics evaluating the entire dataset, but listing the representation per part or characteristic. - "Relating to part type"
The content of the graphics in this group is determined by the "Reference to part" option.
<File> | <Configurations> | <General Settings> | <General Settings 2>
If multiple test plans have been loaded simultaneously and the "Reference to part" option is disabled, the graphic will display the characteristics of all the loaded parts, i.e. the entire loaded dataset. This is regardless of which characteristic is currently active.
When the "Reference to part" option is enabled, only the characteristics of the active part are displayed in the "Part type related" group. - "Characteristic-related"
Various graphics are available in the "Characteristic-related" group, which can be used to assess individual measured values for the currently active characteristic.
Link to: Defective parts summarised by characteristics - First Time Through (FTT) / First Time Yield (FTY)
As the graphics in this tab provide not only an assessment of one characteristic, but a comprehensive assessment of parts with several characteristics and measurements, the settings in the evaluation strategy are influential. Therefore, the graphics for "Total part evaluation" are explained based on the configuration of the evaluation strategy.
Link to: Evaluation Strategy - Total Part Evaluation
The tolerance utilisation graphics show the relative utilisation of the tolerance for each individual measured value, depending on the characteristic type.
Link to: Tolerance Utilisation