Hi,
We have a problem during SP600 calibration with a client. The results show a standard deviation of 2000 and flexion of 0.
The system worked fine before. No changes were made to the PC (Q7 2020 on Windows 10). The client also replaced the calibration sphere, but the problem persists.
I don’t understand the cause or how to fix it.
Any advice?
note:
No DLL message is displayed like this one .<<Could not initialize Renishaw Dll >>
Best regards,
modif
[edited by: Achraf Mraihia at 12:09 PM (GMT -5) on Oct 14, 2025]
